Heavy-Duty Dual-Motor
UNIT: Two piece made of rustproof color proof, shock proof, fire retardant, A.B.
S. Lustran
Motor 35 cm x 84 cm (14” x 33”)
Tank 35 cm x 102 cm (14” x 47”)
VACUUM MOTORS:
(2) Amtek-Lamb 14 Amp. Commercial extractor model 117-500-13 3 stage,
7.2”dia.
FACTORY RATING: 145” water lift, 204 CFM
RECOVERY TANK: The cyclonic separator and cold water spray separate the
water, foam and debris from the air flow without restrictive filters or
mechanical floats. Large debris is contained in a mesh screen while the
liquids automatically dump down the drain.
UTILITY REQUIREMENTS:
ELECTRICAL: 120 volt, 60 hertz, (2) 15 amp standard plugs
WATER: Cold water with shut-off. Hot water (up to 170ºF [77ºC]) with shut-off.
Connect directly to water outlets or to optional cleaning solution injector
(AA031 or AA033).
DRAIN: 2" DWV drain to sewer. A p-trap will be required and vent to meet
plumbing codes.
EXHAUST: If power unit is located in a small room, exhaust air from the
vacuum motor must be exhausted to the outside of the building using the
most direct route possible.
INSTALLATION:
POWER UNIT: Locate in an area where it will be protected from freezing. The
mounting bracket should be firmly attached to a wall stud or masonry wall. A
minimum space of 12” is required from the ceiling and on each side of the
unit. The unit must be mounted high enough above the floor as to allow for
drain connection and easy access to service the debris screen.
Vacuum inlets are conveniently located near doorways, in hallways or other
centrally located areas. The vacuum lines are regular 2” PVC vacuum tubing
and fittings.
WATER OUTLETS: Water Outlets are located next to the vacuum inlets. (In
existing structures where access is limited the outlets may be located under
sinks or on other wall where access is possible. The water lines may be
either 3/8" or 1/2" PEX, 3/8" copper or other equivalent tubing appropriate for
the building with connections made in accessible areas.
COMMERCIAL LIMITED WARRANTY: The manufacturer warrants to the initial
purchaser that the AQUA-AIR Wet/Dry® power unit and cleaning solution
injector will be free from defects in material and workmanship for one (1) year
from the date of the first consumer purchase or one thousand (1000) hours
whichever occur first, and that hoses, tools and other attachments will be free
from defects in material and workmanship for ninety (90) days from the date of
the first purchase.
