UNIT: One piece made of rustproof, color proof, shock proof, fire retardant, A.B.S.
Lustran, 35 cm x 120 cm (14” x 47”)
VACUUM MOTORS: Amtek--Lamb 13.7 amp., model 116765-13, three stage, 5.7”
dia., high performance
FACTORY RATING: 137" water lift, 101 CFM
RECOVERY TANK: The cyclonic separator and cold water spray separate the
water, foam and debris from the air flow without restrictive filters or mechanical
floats. Large debris is contained in a mesh screen while the liquids
automatically dump down the drain.
UTILITY REQUIREMENTS:
ELECTRICAL: 120 volt, 60 hertz, 15 amp standard plug
WATER: Cold water with shut-off. Hot water (up to 170ºF [77ºC]) with shut-off.
Connect directly to water outlets or to optional cleaning solution injector (AA031 or
AA033).
DRAIN: 2" DWV drain to sewer. A p-trap will be required and vent to meet
plumbing codes.
EXHAUST: If power unit is located in a small room, exhaust air from the vacuum
motor must be exhausted to the outside of the building using the most direct
route possible.
INSTALLATION:
POWER UNIT: Locate in an area where it will be protected from freezing. The
mounting bracket should be firmly attached to a wall stud or masonry wall. A
minimum space of 12” is required from the ceiling and on each side of the unit.
The unit must be mounted high enough above the floor as to allow for drain
connection and easy access to service the debris screen.
Vacuum inlets are conveniently located near doorways, in hallways or other
centrally located areas. The vacuum lines are regular 2” PVC vacuum tubing and
fittings.
WATER OUTLETS: Water Outlets are located next to the vacuum inlets. (In
existing structures where access is limited the outlets may be located under
sinks or on other wall where access is possible. The water lines may be either
3/8" or 1/2" PEX, 3/8" copper or other equivalent tubing appropriate for the building
with connections made in accessible areas.
RESIDENTIAL LIMITED WARRANTY: The manufacturer warrants to the initial
purchaser that the AQUA-AIR Wet/Dry® power unit will be free from defects in
material and workmanship for five (5) years from the date of the first consumer
purchase, and that hoses, tools and other attachments will be free from defects
in material and workmanship for one (1) year from the date of the first purchase.
